DARN IT! There I was, tightening down my new throttle servo and I heard it. The dreaded sound of a servo tab cracking! I can't believe it! I wasn't even cranking down on it that hard...or maybe I was (see top left pic)?

This is a problem that has plagued many a RC mechanic since the dawn of time. Servo tabs are VERY fragile and most times, it is hard to get them tight enough without pushing the line between secure and "crack"!

Leave it to FullForce RC to come up with a smart, simple and good looking solution to this age old problem. Welcome aluminum servo clamps. The kit comes with enough tabs to put some serious lock-down power on three complete servos (6 tabs) and the necessary length hardware (see left center pic). Heck! FFRC even gives you an instruction sheet! Let me just say that if you can't figure this out on your own....you need to throw in the towel and take up cross-stitching. Installation is a breeze...just be sure you put the" grove side" down.

Not only do they put a serious hold on your servos, which can lessen servo case flex and put more power to the linkages, the clamps have a tumbled/polished finish and will send your truck up another step on the "bling bling" ladder. And let's not forget about the price. $12 (plus shipping of course) will get you the entire kit (remember that's enough to do three servos).

Got a broken servo tab? Here is your remedy. Even if you don't have broken tab, get them and make sure you never do! This especially goes for those who have invested in a high dollar servo.
These are a simple, yet must have item. There is no reason not to have these on your truck. They just make sense! Did I mention they come in silver, blue and purple?

Visit the FullForce RC web site to pick up some of these clamps and while you are there, check out the dozens of other goodies they have to offer.

Full Force RC Servo Clamp Kit
quality
performance
fit
appearance
cost/value
OVERALL